When a leap second is applied by the kernel, it doesn't actually clear
the STA_INS|STA_DEL bits from the status word, but the state returned
by ntp_adjtime()/adjtimex() is TIME_WAIT until the application clears
the bits.
Add "System clock status reset after leap second" log message for this
case.
Different systems may consider different time values to be valid.
Don't exit on settimeofday()/adjtimex() error in case the check in
UTI_IsTimeOffsetSane() isn't restrictive enough.
This will be used to set the kernel adjtimex() variables to allow other
applications running on the system to know if the system clock is
synchronized and the estimated error and the maximum error.
Since the kernel USER_HZ constant was introduced and the internal HZ
can't be reliably detected in user-space, the frequency scaling constant
used with older kernels is just a random guess.
Remove the scaling completely and let the closed loop compensate for the
error. To prevent thrashing between two states when the system's
frequency error is close to a multiple of USER_HZ, stick to the current
tick value if it's next to the new required tick. This is used only on
archs where USER_HZ is 100 as the frequency adjustment is limited to 500
ppm.
The linux_hz and linux_freq_scale directives are no longer supported,
but allowed by the config parser.
Strip all slewing code (adjtime(), freq locked nano PLL, fast tick
slewing) from the Linux driver and use the new generic frequency only
slewing instead. The advantages include stable clock control with very
short update intervals, good control of the slewing frequency, cheap
cooking of raw time stamps and unlimited frequency offset.
The kernel currently doesn't support a linear adjustment with
programmable rate, extend the use of the kernel PLL with locked
frequency instead.
Set the PLL time constant according to the correction time corresponding
to the correction rate and corrected offset.
On kernels with nano PLL adjtime() is no longer used.
We want to correct the offset quickly, but we also want to keep the
frequency error caused by the correction itself low.
Define correction rate as the area of the region bounded by the graph of
offset corrected in time. Set the rate so that the time needed to correct
an offset equal to the current sourcestats stddev will be equal to the
update interval (assuming linear adjustment). The offset and the
time needed to make the correction are inversely proportional.
This is only a suggestion and it's up to the system driver how the
adjustment will be executed.
