For a long time, the Solaris support in chrony wasn't tested on a real
Solaris system, but on illumos/OpenIndiana, which was forked from
OpenSolaris when it was discontinued in 2010.
While Solaris and illumos might have not diverged enough to make a
difference for chrony, replace Solaris in the documentation with illumos
to make it clear which system is actually supported by the chrony
project.
A while back, support for memory locking and real-time scheduling was
added to more platforms. The chronyd documentation wasn't updated at
that time (chronyd.conf was). This patch fixes that.
Add level "2" to enable a filter which blocks only specific system calls
like fork and exec* instead of blocking everything unknown. It should
be reliable with respect to changes in libraries, but it provides only a
very limited protection.
The -U option can be used to start chronyd under a non-root user if it
is provided with all capabilities and access to files, directories, and
devices, needed to operate correctly in the specified configuration. It
is not recommended in cases where the configuration is unknown.
Add -p option to chronyd to print lines from the configuration as they
are parsed and exit. It can be used to verify the syntax and get the
whole configuration when it is split into multiple files.
macOS 10.13 will implement the ntp_adjtime() system call, allowing
better control over the system clock than is possible with the existing
adjtime() system call. chronyd will support both the older and newer
calls, enabling binary code to run without recompilation on macOS 10.9
through macOS 10.13.
Early releases of macOS 10.13 have a very buggy adjtime() call. The
macOS driver tests adjtime() to see if the bug has been fixed. If the
bug persists then the timex driver is invoked otherwise the netbsd
driver.
If the -Q option is specified, disable by default pidfile, ntpport,
cmdport, Unix domain command socket, and clock control, in order to
allow starting chronyd without root privileges and/or when another
chronyd instance is already running.
Add a new clock driver that doesn't actually try to adjust the clock.
It allows chronyd to run without the capability to adjust/set the system
clock, e.g. in some containers. It can be enabled by the -x option.
This option sets a timeout (in seconds) after which chronyd will exit.
If the clock is not synchronised, it will exit with a non-zero status.
This is useful with the -q or -Q option to shorten the maximum time
waiting for measurements, or with the -r option to limit the time when
chronyd is running, but still allow it to adjust the frequency of the
system clock.
Split and convert the manual into four AsciiDoc documents, a document
about installation and three documents in the manpage type for
chrony.conf, chronyd and chronyc. The minimal man pages that were
maintained separately from the manual are replaced by full man pages
generated from AsciiDoc. Info files will no longer be provided.
Some parts of the manual are rewritten, updated or trimmed. The
introduction chapter is partially merged with README. The chapter about
typical operating scenarios is included in the chrony.conf man page.
