Change the default NTP rate limiting leak to 2 (25%). Change the default
command rate limiting interval to -4 (16 packets per second) and burst
to 8, so the interval is the only difference between NTP and command
rate limiting defaults.
This reverts commit 50022e9286.
Testing showed that ntpd as an NTP client performs poorly when it's
getting only 25% of responses. At least for now, disable rate limiting
by default again.
Change the default interval of both NTP and command rate limiting to -10
(1024 packets per second) and the burst to 16. The default NTP leak is 2
(rate limiting is enabled by default) and the default command leak is 0
(rate limiting is disabled by default).
The maxlockage option specifies in number of pulses how old can be
samples from the refclock specified by the lock option to be paired with
the pulses. Increasing this value is useful when the samples are
produced at a lower rate than the pulses.
The maxjitter directive sets the maximum allowed jitter of the sources
to not be rejected by the source selection algorithm. This prevents
synchronisation with sources that have a small root distance, but their
time is too variable. By default, the maximum jitter is 1 second.
Change default minsamples to 6 and polltarget to 8. This should improve
stability with extremely small jitters (e.g. HW timestamping) and not
decrease time accuracy at minimum polling interval too much.
This option sets a timeout (in seconds) after which chronyd will exit.
If the clock is not synchronised, it will exit with a non-zero status.
This is useful with the -q or -Q option to shorten the maximum time
waiting for measurements, or with the -r option to limit the time when
chronyd is running, but still allow it to adjust the frequency of the
system clock.
If the MAC in NTPv4 requests would be truncated, use version 3 by
default to avoid the truncation. This is necessary for compatibility
with older chronyd servers, which do not respond to messages with
truncated MACs.
This is an incompatible change in the output of the tracking command,
which may break some scripts, but it's necessary to avoid confusion with
IPv4 addresses when synchronised to an IPv6 server or reference clock.
In a burst of three requests (two presend + one normal) the server can
detect the client is using the interleaved mode and save the transmit
timestamp of the second response for the third response. This shortens
the interval in which the server has to keep the state.
Rework the code to make a real request for presend and process the
response, but don't accumulate the sample. This allows presend to work
in the interleaved client mode.
Add support for authenticating MS-SNTP responses in Samba (ntp_signd).
Supported is currently only the old MS-SNTP authenticator field. It's
disabled by default. It can be enabled with the --enable-ntp-signd
configure option and the ntpsigndsocket directive, which specifies the
location of the Samba ntp_signd socket.
Add offset option to the server/pool/peer directive. It specifies a
correction which will be applied to offsets measured with the NTP
source. It's particularly useful to compensate for a known asymmetry in
network delay or timestamping errors.
- fix word order, articles, consistency, and some typos
- avoid slashes, contractions, `may`, dashes in running text
- use colons before example and code blocks
- add Oxford commas
Add maxdrift directive to set the maximum assumed drift of the clock,
which sets the maximum frequency offset chronyd is allowed to use to
to correct the drift.
Similarly to unreachable sources and falsetickers, try to replace
sources with distance larger than the limit set by the maxdistance
directive with a newly resolved address of the hostname.
Add a new option (-c) to chronyc to enable printing of reports in a
column-separated values (CSV) format. IP addresses will not be resolved
to hostnames, time will be printed as number of seconds since the epoch
and values in seconds will not be converted to other units.
