In interleaved client mode, when so many consecutive requests were lost
that the first valid (interleaved) response would be dropped for being
too old, switch to basic mode so the response can be accepted if it
doesn't fail in the other tests.
This reworks commit 16afa8eb50.
In symmetric mode, don't send a packet in interleaved mode unless it is
the first response to the last valid request received from the peer and
there was just one response to the previous valid request. This prevents
the peer from matching the transmit timestamp with an older response if
it can't detect missed responses.
In interleaved symmetric mode, check if the remote TX timestamp is
before RX timestamp. Only the first response from the peer after
receiving a request should pass this test. Check also the interval
between last two remote transmit timestamps when we know the remote poll
can't be constrained by minpoll. Use the minimum of previous remote and
local poll as a lower bound of the actual interval between peer's
transmissions.
If synchronised to a stratum 15 source, return stratum of 16 instead of
0 in the tracking report. It will not match the value in server mode
packets, but it should be less confusing.
Check how many responses were missing before accumulating a sample using
old timestamps to avoid correcting the clock with an offset extrapolated
over a long interval.
This should be eventually done in sourcestats for all sources.
With the new selection of timestamps in the interleaved mode it's no
longer necessary to reverse the poll tracking in order to reduce the
local and remote intervals of measurements that makes the peer with
higher stratum.
This reverts commit 4a24368763.
Use previous local TX and remote RX timestamps for the new sample in the
interleaved mode if it will make the local and remote intervals
significantly shorter in order to improve the accuracy of the measured
delay.
If no CFLAGS are specified, check if common security hardening options
are supported and add them to the CFLAGS/LDFLAGS. These are typically
enabled in downstream packages, but users compiling chrony from sources
with default CFLAGS should get hardened binaries too.
macOS 10.13 will implement the ntp_adjtime() system call, allowing
better control over the system clock than is possible with the existing
adjtime() system call. chronyd will support both the older and newer
calls, enabling binary code to run without recompilation on macOS 10.9
through macOS 10.13.
Early releases of macOS 10.13 have a very buggy adjtime() call. The
macOS driver tests adjtime() to see if the bug has been fixed. If the
bug persists then the timex driver is invoked otherwise the netbsd
driver.
If the -Q option is specified, disable by default pidfile, ntpport,
cmdport, Unix domain command socket, and clock control, in order to
allow starting chronyd without root privileges and/or when another
chronyd instance is already running.
The tai field in struct timex is a Linux-specific feature. It's possible
to read the current offset with ntp_gettime() (or ntp_gettimex() on
Linux), but apparently not all libc implementations support it.
Rework the code to save and adjust the last value instead of reading
the current value from the kernel.
Unlike in the basic mode, the peer with a higher stratum needs to wait
for a response before sending the next request in order to minimize the
delay of the measurement and error in the measured delay.
Slightly increase the delay adjustment to make it work with older chrony
versions.
Update the remote poll and remote stratum even for unsychronised peers,
and handle stratum of 0 as 16, so the peers work with the opposite
differences between their strata and can adjust their polling intervals
in order to interleave the packets.
Use the timezone specified by the leapsectz directive to get the
current TAI-UTC offset and set the offset of the system clock in order
to provide correct TAI time to applications using ntp_adjtime(),
ntp_gettime(), or clock_gettime(CLOCK_TAI).
