Add a new clock driver that doesn't actually try to adjust the clock.
It allows chronyd to run without the capability to adjust/set the system
clock, e.g. in some containers. It can be enabled by the -x option.
This option sets a timeout (in seconds) after which chronyd will exit.
If the clock is not synchronised, it will exit with a non-zero status.
This is useful with the -q or -Q option to shorten the maximum time
waiting for measurements, or with the -r option to limit the time when
chronyd is running, but still allow it to adjust the frequency of the
system clock.
Split and convert the manual into four AsciiDoc documents, a document
about installation and three documents in the manpage type for
chrony.conf, chronyd and chronyc. The minimal man pages that were
maintained separately from the manual are replaced by full man pages
generated from AsciiDoc. Info files will no longer be provided.
Some parts of the manual are rewritten, updated or trimmed. The
introduction chapter is partially merged with README. The chapter about
typical operating scenarios is included in the chrony.conf man page.
