macOS 10.13 will implement the ntp_adjtime() system call, allowing
better control over the system clock than is possible with the existing
adjtime() system call. chronyd will support both the older and newer
calls, enabling binary code to run without recompilation on macOS 10.9
through macOS 10.13.
Early releases of macOS 10.13 have a very buggy adjtime() call. The
macOS driver tests adjtime() to see if the bug has been fixed. If the
bug persists then the timex driver is invoked otherwise the netbsd
driver.
If the -Q option is specified, disable by default pidfile, ntpport,
cmdport, Unix domain command socket, and clock control, in order to
allow starting chronyd without root privileges and/or when another
chronyd instance is already running.
Add a new clock driver that doesn't actually try to adjust the clock.
It allows chronyd to run without the capability to adjust/set the system
clock, e.g. in some containers. It can be enabled by the -x option.
This option sets a timeout (in seconds) after which chronyd will exit.
If the clock is not synchronised, it will exit with a non-zero status.
This is useful with the -q or -Q option to shorten the maximum time
waiting for measurements, or with the -r option to limit the time when
chronyd is running, but still allow it to adjust the frequency of the
system clock.
Split and convert the manual into four AsciiDoc documents, a document
about installation and three documents in the manpage type for
chrony.conf, chronyd and chronyc. The minimal man pages that were
maintained separately from the manual are replaced by full man pages
generated from AsciiDoc. Info files will no longer be provided.
Some parts of the manual are rewritten, updated or trimmed. The
introduction chapter is partially merged with README. The chapter about
typical operating scenarios is included in the chrony.conf man page.
