Add an option to enable NTS for an NTP source. Check for NTS-specific
extension fields and pass the packets to the NTS-NTP code in order to
enable the NTS client and server.
Add an option to use the median filter to reduce noise in measurements
before they are accumulated to sourcestats, similarly to reference
clocks. The option specifies how many samples are reduced to a single
sample.
The filter is intended to be used with very short polling intervals in
local networks where it is acceptable to generate a lot of NTP traffic.
Allow SRC_MAYBE_ONLINE to be specified for new NTP sources and
connectivity setting to select between SRC_ONLINE and SRC_OFFLINE
according to the result of the connect() system call, i.e. check whether
the client has a route to send its requests.
When the burst option is specified in the server/pool directive and the
current poll is longer than the minimum poll, initiate on each poll a
burst with 1 good sample and 2 or 4 total samples according to the
difference between the current and minimum poll.
Change default minsamples to 6 and polltarget to 8. This should improve
stability with extremely small jitters (e.g. HW timestamping) and not
decrease time accuracy at minimum polling interval too much.
Add xleave option to the peer directive to enable an interleaved mode
compatible with ntpd. This allows peers to exchange transmit timestamps
captured after the actual transmission and significantly improve
the accuracy of the measurements.
Add offset option to the server/pool/peer directive. It specifies a
correction which will be applied to offsets measured with the NTP
source. It's particularly useful to compensate for a known asymmetry in
network delay or timestamping errors.
Require that at least one of the sources specified with this option is
selectable (i.e. recently reachable and not a falseticker) before
updating the clock. Together with the trust option this may be useful to
allow a trusted, but not very precise, reference clock or a trusted
authenticated NTP source to be safely combined with unauthenticated NTP
sources in order to improve the accuracy of the clock. They can be
selected and used for synchronization only if they agree with the
trusted and required source.
Assume time from a source that is specified with the trust option is
always true. It can't be rejected as falseticker in the source
selection if sources that are specified without this option don't agree
with it.
The minsamples and maxsamples directives now set the default value,
which can be overriden for individual sources in the server/peer/pool
and refclock directives.
A new option can be now used in the pool directive: maxsources sets the
maximum number of sources that can be used from the pool, the default
value is 4.
On start, when the pool name is resolved, chronyd will add up to 16
sources, one for each resolved address. When the number of sources from
which at least one valid reply was received reaches maxsources, the
other sources will be removed.
Require that the ratio of the increase in delay from the minimum one in
the stats data register to the standard deviation of the offsets in the
register is less than maxdelaydevratio or the difference between
measured offset and predicted offset is larger than the increase in
delay. In the allowed delay increase is included also skew and maximum
clock frequency error.
maxdelaydevratio is 10.0 by default.
Instead of following skew changes, adjust polling interval so that the
number of measurements used in the regression algorithm remains close to
a target value. It can be configured with a new polltarget option
(6 by default).
This is a verbatim copy of the files at that stage of the repository that was
built from the CVS import. It allows future development to see a bit of recent
history, but without carrying around the baggage going back to 1997. If that
is really required, git grafts can be used.
