leapsectz directive is used to set the name of the timezone in the
system tz database which chronyd can use to find out when will the next
leap second occur. It will periodically check if dates Jun 30 23:59:60
and Dec 31 23:59:60 are valid in that timezone. This is mainly useful
with reference clocks which don't provide the leap second information.
It is not necessary to restart chronyd if the tz database is updated
with a new leap second at least 12 hours before the event.
This directive sets the maximum allowed offset corrected on a clock
update. The check is performed only after the specified number of
updates to allow a large initial adjustment of the system clock. When
an offset larger than the specified maximum occurs, it will be ignored
for the specified number of times and then chronyd will give up
and exit (a negative value can be used to never exit). In both cases
a message is sent to syslog.
The corrtimeratio directive controls the ratio between the
duration in which the clock is slewed for an average correction
according to the source history and the interval in which the
corrections are done (usually the NTP polling interval). Corrections
larger than the average take less time and smaller corrections take
more time, the amount of the correction and the correction time are
inversely proportional.
Increasing corrtimeratio makes the overall frequency error of
the system clock smaller, but increases the overall time error as
the corrections will take longer.
By default, the ratio is 1, which means the duration of an average
correction will be close to the update interval.
Instead of always selecting the source with minimum stratum, add weighted
stratum to the distance when comparing selectable sources. The weight
can be configured with new stratumweight directive and can be set to
zero to ignore stratum completely, by default 1.0.
Each source has a score against currently selected source which is
updated (multiplied by ratio of their distances) when one of the two
sources has a new sample. When the score reaches a limit, the source
will be selected. This should allow to slowly select the source with
minimum distance without frequent reselecting.
To avoid switching between sources with very variable distances (e.g. on
LAN or when upstream server uses a longer polling interval), sources
that are currently not selected are penalized by a fixed distance. This
can be configured with new reselectdist directive (100 microseconds by
default).
Require that the ratio of the increase in delay from the minimum one in
the stats data register to the standard deviation of the offsets in the
register is less than maxdelaydevratio or the difference between
measured offset and predicted offset is larger than the increase in
delay. In the allowed delay increase is included also skew and maximum
clock frequency error.
maxdelaydevratio is 10.0 by default.
Instead of following skew changes, adjust polling interval so that the
number of measurements used in the regression algorithm remains close to
a target value. It can be configured with a new polltarget option
(6 by default).
A new tempcomp directive can be used to specify a file for reading
current temperature, update interval and compensation coefficients. The
clock frequency corrections are applied in local module and are invisible
in upper layers. The measurements and corrections can be logged to
tempcomp.log file.
Fallback drifts are long-term averages of the system clock drift
calculated over exponentially increasing intervals. They are used when
the clock is unsynchronised to avoid quickly drifting away from true
time if there was a short-term deviation in drift before the
synchronisation was lost.
