Fix the FreeBSD-specific code checking for a bound IPv4 socket to
include the new PTP port. This should fix a multihomed server to respond
to NTP-over-PTP requests from the address which received the request.
Fixes: be3158c4e5 ("ntp: add support for NTP over PTP")
In the FreeBSD-specific code checking for a bound IPv4 socket, make
sure it is not a Unix domain address to avoid reading uninitialized
IP-specific fields.
This fixes an error reported by valgrind.
Zero the whole sockaddr struct before calling bind() and connect() to
initialize the FreeBSD-specific sa_len field.
This fixes errors reported by valgrind.
Avoid searching the hash table of sources when a packet in the client
mode is received. It cannot be a response from our source. Analogously,
avoid source lookups for transmitted packets in the server mode. This
doesn't change anything for packets in symmetric modes, which can be
requests and responses at the same time.
This slightly improves the maximum packet rate handled as a server.
For a long time, the Solaris support in chrony wasn't tested on a real
Solaris system, but on illumos/OpenIndiana, which was forked from
OpenSolaris when it was discontinued in 2010.
While Solaris and illumos might have not diverged enough to make a
difference for chrony, replace Solaris in the documentation with illumos
to make it clear which system is actually supported by the chrony
project.
The dosynctodr kernel variable needs to be set to 0 to block automatic
synchronization of the system clock to the hardware clock. chronyd used
to disable dosynctodr on Solaris versions before 2.6, but it seems it is
now needed even on current versions as the clock driver sets frequency
only without calling adjtime() or setting the ntp_adjtime() PLL offset.
This issue was reproduced and fix tested on current OpenIndiana.
Fixes: 8feb37df2b ("sys_solaris: use timex driver")
In addition to the 16s limit in per-response change in the monotonic
offset, don't allow the total accumulated offset injected in sourcestats
to be larger than 16 seconds.
Check that the leap_when variable is set before testing a timestamp for
being close to a leap second. This allows the first measurement to be
accepted if starting at the Unix epoch (e.g. in a test).
Calculate the delay since the previous transmission only if the
TX timestamp is actually set. This removes an unnecessary delay when
starting at the Unix epoch in 1970 (e.g. in a test).
It seems there is no longer an issue with the first sample after the
initial trim and it can be accumulated. It might have been a workaround
for an unrelated bug which was fixed since then.
This fixes the number of samples reported in rtcdata briefly jumping to
65535 and also brings back the expectation that n_samples is never
negative.
Some of the code (e.g. util and clientlog) may work with negative
values. Require that time_t and the tv_nsec types are signed. This seems
to be the case on all supported systems, but it it is not required by
POSIX.
Close /dev/urandom and drop cached getrandom() data after forking helper
processes to avoid them getting the same sequence of random numbers
(e.g. two NTS-KE helpers generating cookies with identical nonces).
arc4random() is assumed to be able to detect forks and reseed
automatically.
This is not strictly necessary with the current code, which does not use
the GetRandom functions before the NTS-KE helper processes are forked,
but that could change in future.
Also, call the reset function before exit to close /dev/urandom in order
to avoid valgrind reporting the file object as "still reachable".
Don't ignore the magic field when searching for the exp1 extension
field in a received response. If there were two exp1 fields in the
packet, and only one of them had the expected magic value, it should
pick the right one.
Fixes: 2319f72b29 ("ntp: add client support for experimental extension field")
If the xleave option is enabled, ignore the key option and the hash
length. Always use version 4 as the default to get interleaved responses
from new chrony servers.
The interleaved modes are being specified for NTPv4 only. As a server,
detect interleaved requests only in NTPv4 packets.
Clients and peers can still send interleaved requests in lower-version
packets if configured with the version option.
Frequency transfer and time smoothing are conflicting features. Set the
monotonic timestamp in the experimental extension field to zero
(invalid) if time smoothing is activated.
The maximum value of the new 32-bit fields is slightly less than 16,
which can cause the NTP test #7 to pass for a server which has a zero
root delay but maximum root dispersion.
Interpret the maximum value as the maximum value of the original 32-bit
fields (~65536.0 seconds) for better compatibility with NTPv4.
Add "extfield F323" option to include the new extension field in
requests. If the server responds with this field, use the root
delay/dispersion and monotonic timestamp. Accumulate changes in the
offset between the monotonic and real-time receive timestamps and use
it for the correction of previous offsets in sourcestats. In the
interleaved mode, cancel out the latest change in the offset in
timestamps of the previous request and response, which were captured
before the change actually happened.
Maintain a server monotonic timescale needed for the experimental
extension field. It follows the best estimate of frequency without
time corrections. Implement it as an offset relative to the NTP time,
starting at zero, using a slew handler to cancel time corrections of the
NTP clock. The 32-bit epoch ID is set to a random value on start and
every step of the system clock.
Add an experimental extension field for some features that were proposed
for NTPv5. Higher-resolution root delay and dispersion (using 28-bit
fraction) are added. A monotonic receive timestamp will allow a
frequency transfer between the server and client. The client will be
able to separate the server's time corrections from frequency
corrections by tracking the offset between the real-time and monotonic
receive timestamps.
The field has a type of 0xF323 from the new experimental range proposed
by the NTP working group. Include a magic 32-bit value in the field to
avoid interoperability issues if a different implementation choses the
same type for its own experimental field. The value will be changed on
incompatible changes to avoid issues between two different chrony
versions.
Add a new variable to the packet info structure with flags for extension
fields included in received packets and add a new parameter to
transmit_packet() to add the fields to transmitted packets.
Since commit fdfcabd79b ("ntp: drop support for long NTPv4 MACs"), the
parser doesn't need to check validify of MACs in NTPv4 packets to
distinguish them from extension fields. Move the parser to ntp_core to
avoid having a separate iteration looking for non-authentication
extension fields.
Add extra space to the socket message buffer to be able to receive
maximum-length NTP-over-PTP SW/HW-timestamped messages from the Linux
error queue (which are looped back as layer-2 frames).
When calculating the root delay and dispersion of a sample measured in
the interleaved mode, use the root delay and dispersion values from
the previous response (to which the TX timestamp corresponds). If the TX
timestamp is combined with the RX timestamp of the latest response (e.g.
in the symmetric mode), use the maximum of the previous and latest root
delay/dispersion.
When the server clock was updated between saving of the RX timestamp and
updating the TX timestamp, a client using interleaved mode with the four
timestamps which minimize error in measured delay (e.g. chrony) had the
server clock adjustment included in the measured delay, which could
disrupt the sample filtering and weighting.
Add a handler to track the slew epoch and remember the last offset. Undo
the adjustment in TX timestamps which have their RX timestamp in the
previous epoch to fix the delay observed by the clients.
If an unknown clock step is detected, drop all timestamps.
Don't save server RX and TX timestamp to clientlog if the transmission
or authentication failed (e.g. packet is handled in ntp_signd). They
will not be needed.
Zero the initial TX timestamp which is saved for the interleaved
mode in case there is no previous timestamp saved in clientlog and
transmit_packet() does not generate a new one (e.g. due to failure in
authentication).
Fixes: 5f4cbaab7e ("ntp: optimize detection of clients using interleaved mode")
Report the number of received interleaved requests and current timestamp
count with their span.
Expand the serverstats description in chronyc man page.
When responding to a request, don't waste time with TX timestamping
if the timestamp will not be saved (i.e. clientlog is disabled).
Fixes: 5f4cbaab7e ("ntp: optimize detection of clients using interleaved mode")
